Page 1 of 1

Ability to rotate piece around point other than the center.

PostPosted: June 21st, 2008, 6:45 pm
by brian448
Is it possible to rotate a piece around a point other than the center or the corner?

I have a piece whose pivot point is near the bottom middle of the piece. I need a way to rotate the piece around this point.

I can get around the problem by increasing the size of the piece so that the old pivot point is now the new center of the enlarged piece.

It would be much easier if I could tell the piece directly where its pivot point is.

Ability to rotate piece around point other than the center.

PostPosted: June 21st, 2008, 9:19 pm
by Brent Easton
Is it possible to rotate a piece around a point other than the center or
the corner?

I have a piece whose pivot point is near the bottom middle of the piece.
I need a way to rotate the piece around this point.

I can get around the problem by increasing the size of the piece so that
the old pivot point is now the new center of the enlarged piece.

It would be much easier if I could tell the piece directly where its pivot
point is.

The Pivot trait does this.

B.


_______________________________________________
Messages mailing list
Messages@forums.vassalengine.org
http://forums.vassalengine.org/mailman/ ... engine.org

Post generated using Mail2Forum (http://www.mail2forum.com)