Page 1 of 1

Pacific War Vassal Module PWv1.66

PostPosted: November 7th, 2019, 3:39 pm
by bond007jlv
I an setting up the Strategic Campaign.
The British setup has deployment of 3 steps of 2E-L0, 1 step of 2E-L0 and 2 steps of 2E-L0.
In the couner mix there is a full step (6 steps) 2E-L0 counter.
But I cannot not split to deploy to different hexes.
How can I split the single full step unit into different steps to different hexes?

Re: Pacific War Vassal Module PWv1.66

PostPosted: February 6th, 2020, 5:02 pm
by cjcrock
I'm pretty sure you have to add two new air units to the map or force card (from the counter mix) and then add the number of step losses to them to get the correct strength. This is how you would do it if you were playing the paper game table top. There is no provision to automatically split something into multiple somethings.