Is it possible to rotate a piece around a point other than the center or the corner?
I have a piece whose pivot point is near the bottom middle of the piece. I need a way to rotate the piece around this point.
I can get around the problem by increasing the size of the piece so that the old pivot point is now the new center of the enlarged piece.
It would be much easier if I could tell the piece directly where its pivot point is.
The Pivot trait does this.
B.
Messages mailing list
Messages@forums.vassalengine.org
forums.vassalengine.org/mailman/ … engine.org
Post generated using Mail2Forum (mail2forum.com)