[messages] [Module Design] Card stacking problem

Thomas Russ tar at isi.edu
Wed May 25 09:30:03 MST 2011


On May 24, 2011, at 9:14 PM, anonemous123 wrote:

> Is there someway I can tell it to stack the cards
> so that each card above the first card is placed about 1/4 of the card
> height "up" the page i.e. so that the lower 1/4 of each card below the
> top card is always visible in the stack?

Under "Map Window" there is a "Stacking Options" panel where you can  
set the values for expanded and not-expanded separations.  If you  
increase the vertical non-expanded separation to be 1/4 of the card  
size in pixels, you should get the stacking behavior that you desire.




More information about the messages mailing list