[messages] [Technical Support & Bugs] Place Marker Not acting the same as moving marker from parts

fw190d11 cr125rulz at gmail.com
Thu Jun 29 14:43:01 CEST 2017

happens every time.  I drag a unit counter from parts window to map. I
select a submenu called risky action, select construct ip from sub menu.
this calls a place marker command to place a ip-construct marker below
the unit counter. this finishes the action of the unit and at this point
the turn phase is advanced via gkc and status checks are made on the
unit counter. then finally a clearstatus resets the unit counter status
and triggers the replace marker command to replace the ip-c with an ip
marker below the unit counter that placed the ip-c marker. the ip marker
appears but the ip-c marker remains above the ip marker, below the unit
counter and then error message.

I will be happy to send the code. i am travelling right now. so may take
a day or so.
thanks everone
Dave b

Read this topic online here:

More information about the messages mailing list